MACHINE CONTROL SERVICES.  1185 CR 1535 Mount Pleasant, Texas. 75455  

    Phone (903) 577-0569    Fax (903) 572- 5035

REPAIR INFORMATION PLEASE READ CAREFULLY BEFORE SENDING ANY ITEM FOR REPAIR

1.     You will be issued an RA number. This is your Repair Authorization number.
Please record it for any further contact about the status or questions about your item.

2.     When sending in an item for repair, request a signature from the receiving party for proof of receipt.

3.     Insure for the replacement Value of the item and pack item with at least two inches of packing on all sides and ends of the item.

UPON RECEIVING A REPAIRED ITEM YOU MUST DO THE FOLLOWING!

1.     Check package for any damage before accepting the box.

2.     If acceptable, open box and check item for any visible damage including missing Screws, Fuses, Relays or other parts shaken loose in shipping.

3.     If all appears ok, use only a Factory Certified Electrical CNC Maintenance Engineer or Technician to install, adjust, align and test repaired unit.
If you do not use a Factory trained qualified service engineer to do these critical setup, adjustments and tests it will null and void our 90 day warranty. There are peripheral components and set-up procedures that can cause these units to go bad immediately or shortly after running the machine.
 

Thomas Jaeger DBA
Machine Control Services